Sign up for our e-news!

CONTACT US

 

SEARCH SITE

 


Wine Makers

Sulfur Dioxide Additions for Wine Making

Sulfur dioxide (SO2) is added to both must and wine for protection from oxidation and microbial spoilage. Sulfur dioxide is highly reactive and a large portion (roughly half) of the compound is bound up immediately after addition. The remainder of the sulfur dioxide is called free SO2 with a very small portion remaining as molecular SO2. It is the molecular SO2 that gives protection from microbes. Molecular SO2 levels should be maintained between 0.5 and 0.8 ppm for proper protection.   The quantity of sulfur dioxide added depends on many factors. The most important factors to consider are:
 
  • pH of must or wine
  • temperature of must or wine
  • condition of fruit at crush
  • type of wine being produced
 
pH:
The pH of the solution that the sulfur dioxide is added to is a major determining factor in the quantity of sulfur dioxide needed to provide adequate protection from microbes and oxidation. A lower pH solution will require less sulfur dioxide in order to maintain the proper level of molecular SO2. There is a very large difference in quantity of SO2 needed between a pH of 3.0 and 4.0. 
 
Temperature:
As temperatures increase, less stable compounds that bind SO2 release those bonds, which in turn, increases the level of free SO2 in the solution.
 
Condition of Fruit at Crush:
The condition of the fruit when it is crushed is an important factor in the amount of necessary SO2 additions. When fruit is rotten or moldy or is suspected of having high levels of microorganisms present, more SO2 must be added (50-100%). Fruit that is in poor condition contains higher levels of aldehydes which bind to added SO2.
 
Fruit that is in exemplary condition at crushing may not even need to be sulfited before fermentation.
 
Type of Wine Being Produced:
The type of fruit and the style of wine being produced will have an impact on sulfiting decisions. Typically white grapes are sulfited at crushing to protect against browning due to oxidation as well as for protection against microbial infection. Red grapes are also sometimes sulfited at crushing to help with color extraction and for protection against microbial infection.
 
Timing of Additions:
Quantity of sulfite added and the timing of sulfite additions are dependent on many factors including the factors listed above. Winemaking is a complex science/art that has as many varied answers for each question that can be asked. The best advice is to obtain as much information as possible and then use that information to make an informed decision for your own unique situation. That said, the following is a rough estimate of typical sulfiting quantities and schedules. These are very rough and should be modified to fit each winemaker’s individual situation.
 
            Red Wine:
1.      At crushing, add 50 ppm sulfite. Let stand overnight and inoculate with yeast.
2.      After ML fermentation is complete, dose with 50 ppm sulfite.
3.      Monitor and adjust aging red wine to 20 ppm free SO2.
4.      Adjust SO2 level to 25 ppm before bottling.
 
            White Wine:
1.      Must not intended to undergo ML fermentation should have 80 ppm sulfite added at crushing.
2.      Must intended to undergo ML fermentation should have 50 ppm sulfite added at crushing.
3.      For wine not undergoing ML fermentation, 50 ppm SO2 should be added at dryness.
4.      For wine undergoing ML fermentation, 50 ppm SO2 should be added when ML fermentation is complete.
5.      Wine held before bottling should be monitored and maintained at 20 ppm free SO2.
6.      Wine should be adjusted to 25 ppm free SO2 at bottling.
 
 


Wyeast Laboratories, Inc. © 2014 All rights reserved.
PO Box 146, Odell, OR 97044, USA

Site by Locus Interactive